PANTHEON CONCRETE SEALER

APPLICATION
The product may be applied to broomed, steel troweled, honed, polished or highly polished interior concrete surfaces.
NOTE: Do NOT use a string mop to apply Pantheon Concrete Sealer.

1. Fill pump sprayer with Pantheon. Mix well. Lightly wet a clean microfiber pad with Pantheon Concrete Sealer, leaving the pad damp.
2. Spray-apply Pantheon to the surface. Spread with a flat mop and damp microfiber pad.  Work from one control joint to another.
   NOTE: If floor is porous or rough, use a pour can and heavyweight T-bar to apply.
3. Maintain a thin, even coating and wet edge. Stop spreading once drying begins. Do not overlap. Rinse mop between coats.
4. Allow to dry tack free, typically 20-40 minutes.
5. Repeat steps 1-4. Two coats minimum for stain protection. 3-4 coats for high gloss results.

FOR CURE ‘N SEAL USE:

1. Spray-apply at a rate of 200-400 sq. ft. per gallon (5-10 m² per liter) depending on conditions. If applying to raw concrete that has never been polished, apply at a rate of 300-500 sq. ft. per gallon (7-12 m² per liter). Coverage will improve after each coat.
2. If desired, for a more uniform appearance, use a roller applicator with ½-inch nap.

Protect from water for 4 hours. At 72°F (22°C) and 40% relative humidity, product dry times are:

• To Touch: 30-60 minutes
• Light Foot Traffic: 4 hours
• Normal traffic: overnight

The product gains its full stain repellency properties in 7 days.